If your furnace is aging, unreliable, unsafe or becoming expensive to repair, Climax Energy can assess the existing system and help you compare replacement options. We review the home's heating requirements, ductwork, equipment location, venting and installation conditions before recommending suitable equipment.
North Vancouver's mix of older mountain-district homes, hillside properties, strata buildings, and bi-level layouts creates a range of replacement conditions. The right equipment choice depends on the specific home, not a general recommendation.
Homes built through the 1960s and 70s in North Vancouver's mountain districts often have original ductwork, natural-draft venting, and gas piping that may need updating alongside the furnace. Replacement scope here can extend beyond the equipment itself.
Split-entry and bi-level homes are common on North Vancouver's slopes. Airflow between levels, equipment placement in partial basements, and venting routes can be more constrained than in a standard detached home.
Strata properties have mechanical room size limits, shared wall considerations, and strata approval processes that affect what equipment can be installed and how venting is routed.
North Vancouver's higher rainfall and humidity levels affect combustion air supply, condensate drainage for high-efficiency equipment, and ductwork condition over time. We assess these factors at the site visit.
Replacement isn't always the answer — but there are situations where continuing to repair an aging furnace costs more than replacing it. We don't make this call for you; we walk through the factors that should inform your decision.
Replacing a furnace isn't just swapping one unit for another. These are the steps we follow to make sure the replacement is done right.
We visit the home and review the existing furnace, venting configuration, ductwork condition, combustion air supply, gas line, and mechanical room. This shapes everything that comes after.
Heating load is calculated for your home's actual square footage, insulation, windows, and configuration — not assumed from the old unit's capacity.
We recommend equipment matched to your load calculation, installation constraints, and fuel cost priorities. We discuss the options with you before ordering.
Where required, permits are pulled. Gas and electrical scope is confirmed. Scheduling is coordinated with you.
The old unit is removed and disposed of. The new furnace is installed, venting is set, gas connections are made and tested, controls are wired and programmed.
We test the system under load, verify combustion, check airflow and temperature rise, and walk you through the new equipment's operation.
We don't publish price ranges because furnace replacement scope varies considerably. A straightforward like-for-like swap costs less than a project that also requires venting changes, duct modifications, or gas line work.
We assess the site before quoting — no estimates from square footage alone.
Some homeowners use a furnace replacement as an opportunity to consider switching to a heat pump. The right choice depends on your home's ductwork, heating load, and priorities. There's no universal answer.
We can walk through both options for your North Vancouver home at the assessment. See current rebate eligibility before making a decision if rebates are a factor.
We're a local trade contractor — not a national franchise. Our assessments are done by technicians, not salespeople.
We scope the full project before quoting, including venting, ductwork, gas line, combustion air, and equipment access. No surprises after the job starts.
Equipment is sized to a calculated heating load, not the old furnace's nameplate or your home's square footage.
We handle the complete scope of a furnace replacement — not just the unit itself.
We work regularly in North Vancouver and are familiar with the housing types, neighbourhood conditions, and common installation challenges here.
Call (250) 201-2030 or use the chat button below